Kenwood TS-590S Manual Do Utilizador

71

You will require a #1 Philips screwdriver to install the 
VGS-1 or SO-3 TCXO.  You will also need a soldering 
iron (approx. 30 watts) to install the SO-3 TCXO.

Switch OFF the transceiver power and unplug the DC power 
cable before performing any installations.

When installing the optional VGS-1 or SO-3 TCXO, 
remove the bottom case of the transceiver:

1 Remove the 10 screws.

2 Lift off the bottom case.

1 Remove the shield cover (4 screws).

2 There are 5 rubber cushions in the VGS-1 

package.  Use the 2 rubber cushions shown below 
(20 x 30 x 2 mm and 21 x 21 x 2.5 mm) and attach 
them to the VGS-1.

•

The remaining cushions are not used.

3 Plug the VGS-1 into the VGS-1 connector of the 

PC board, pressing down on the top of the VGS-1 
until secure.

4 Replace the shield cover and tighten the 4 screws.

5 Replace the bottom case (10 screws).

Note:  After installation, you can adjust the VGS-1 playback and 
voice guide volume by selecting Menu Nos. 05 and 06.