Korg Ax3000b Manual Do Utilizador

19

Here’s how you can name a program.

NOTE: The program name is saved as part of each program. If you switch to a dif-
ferent program or turn off the power before you save, your settings will be lost.

1. Press the RENAME button.

2. Use the √

√

√

√

/®

®

®

®

 buttons to move the cursor to the character you want to change 

(the selected character blinks), and use value knob 1 or the 

▲/▼ buttons to 

change the character.

You can use the following characters.

3. Repeat step 2 to finish entering a name for your program.

4. When you’ve finished entering a name, press the EXIT button  to return to the 

mode you were in.

When your tweaking has resulted in a sound you’re happy with, store (write) it!

1. Press the WRITE button.

The name display shows “*WRITE*” and the bank display and program LEDs 
1–4 will blink.

2. Use value knob 1 or the 

▲/▼ buttons to select the bank you want to use, and 

use the √

√

√

√

/®

®

®

®

 buttons to select the destination program 1–4.

For example if you want to store your program in 9-1 (bank 9, program 1), use 
value knob 1 or the 

▲/▼ buttons to make the bank display show “9,” and then 

use the √

√

√

√

/®

®

®

®

 buttons to make the program 1 switch LED blink.

HINT: You can also select the store-destination program by using the BANK UP/
DOWN switches or the program 1–4 select switches.

3. Press the WRITE button once again.

The program will be saved, the name display will indicate “COMPLETE,” and 
you will return to Program Select mode.

NOTE: The program writes over the previous contents of that bank/program. The 
program that previously occupied the number you selected in step 2 will be erased.

NOTE: If you decide not to store your new program, press the EXIT button to can-
cel the procedure.

NOTE: If you switch to a different program or turn off the power without storing the 
program you edited, your changes will be lost.