Crestron electronic WMKM-6X-DSW Manual Do Utilizador

 Mud Mount Kits for the TPS-6X-DSW 

Crestron MMK/WMKM-6X-DSW

BACK OF DRYWALL

 

10.  Use four standard drywall screws (length should not exceed drywall 

thickness by more than 1/2 inch) to secure the mud ring plate to the 
adjustment/mounting plate assembly. The screws are secured in the 
extruded holes of the adjustment plate and pass through the clearance 
holes in the mounting plate. 

11.  Verify that the plate is level before tightening. 

NOTE:  Do not over tighten screws. Doing so may damage the plate. 

12.  Use a #2 Phillips screwdriver and tighten the drywall screws by hand 

so that they slightly dimple into the holes in the mud ring plate. 

13.  Run the necessary cables for the TPS-6X-DSW and secure them behind 

the drywall. 

14.  Apply drywall joint compound as needed to finish the cutout. Avoid 

covering the four tapped mounting holes. 

15.  When the joint compound is dry, the wall mount docking station can be 

installed using the four tapped holes in the mounting plate. Refer to the 
latest revision of the TPS-6X-DSW Operations and Installation Guide 
(Doc. 6708) for details. Refer also to the comprehensive illustration on 
the following page. 

•  Mud Mount Kits for the TPS-6X-DSW: MMK-6X-DSW & WMKM-6X-DSW