Kenwood TS-570S TS-570D Manual Do Utilizador

57

The following equipment is required for installing the
optional units.

•

Large Philips screwdriver

•

Small Philips screwdriver

•

25 W pencil soldering iron (for the SO-2 unit only)

When installing the optional DRU-3A, VS-3, or SO-2
unit, remove the bottom case first.

1 Remove the 8 screws.

2 Lift off the bottom case.

 SWITCH OFF THE POWER AND UNPLUG THE DC

POWER CABLE BEFORE BEGINNING INSTALLATION.

1 Remove the bottom case (8 screws).

2 Remove the flat cable from the CN15 connector.

3 Peel off the paper backing from the cushion installed

on the transceiver PC board.

Cushion

CN15

CN17

4 Plug the DRU-3A connector (CN901) into the CN17

connector.

•

The large IC on the DRU-3A must closely contact
the cushion on the PC board.

5 Reconnect the flat cable to the CN15 connector.

6 Replace the bottom case (8 screws).

DRU-3A