Xerox 135 Manual Do Utilizador
Supplies
A-2
Installation Planning Guide
•
US Ledger/US Tabloid: 11 by 17 inches / 279 by 432 mm
•
A3: 11.69 by 16.54 inches / 297 by 420 mm
Recommended
weight and grade
Use a good quality, xerographic-grade paper. For best results,
use paper that is 20-pound or 80 gsm (grams per square meter)
bond, xerographic grade. Xerox 4024 Dual Purpose Paper
provides optimal performance in the printer. (Refer to the
consumable supplies table later in this appendix.)
use paper that is 20-pound or 80 gsm (grams per square meter)
bond, xerographic grade. Xerox 4024 Dual Purpose Paper
provides optimal performance in the printer. (Refer to the
consumable supplies table later in this appendix.)
Use paper within these parameters:
•
Lightest: 16-pound (65 gsm) bond
•
Heaviest: 110-pound (200 gsm) index
Characteristics
The paper stock should have the following characteristics:
•
Low moisture content (a paper-to-moisture ratio below 5.7
percent). Paper with higher moisture content may curl and
jam.
percent). Paper with higher moisture content may curl and
jam.
•
Smooth surface
•
Moisture-resistant wrapping
•
No defects (bent edges, uneven surfaces)
•
Grain long (parallel with the long side of paper)
Paper is usually fed into the printer with the long side as the
leading edge (except 11 by 17-inch or A3 paper). When you
purchase paper, buy long-grain paper. Make sure the grain is
parallel with the long side (long-grain) for the most reliable
feeding and stacking.
leading edge (except 11 by 17-inch or A3 paper). When you
purchase paper, buy long-grain paper. Make sure the grain is
parallel with the long side (long-grain) for the most reliable
feeding and stacking.
Special stocks
Following are some guidelines for choosing and using special
materials:
materials:
•
Labels: Must be the type designed for high-speed printers
and must meet the specifications described in the section
above. Loading instructions are printed on all paper trays.
and must meet the specifications described in the section
above. Loading instructions are printed on all paper trays.
Use only the processor feeding trays (trays 1 and 2) for
labels. Load labels in the tray with the label side up.
labels. Load labels in the tray with the label side up.
You can direct printed labels to any output tray. Be sure the
printed labels are stacked face up in the output tray, to avoid
ink offsetting and jams due to delamination.
printed labels are stacked face up in the output tray, to avoid
ink offsetting and jams due to delamination.