Dialogic M7324 Manual Do Utilizador

As shown in 

, there are six Display Keys or Soft Keys located below 

the LCD display on the Mitel Superset 430 telephone. These keys are 
associated with specific prompts shown on the LCD display depending on the 
current state of the phone.  

In order to read the soft key prompts from the Mitel Superset 430 
phone, 160 bytes of display data must be read that was not supported 
until Dialogic

® 

System Release Software 5.1.1 Feature Pack 1. Use 

the d42_displayex( ) function to get 160 bytes of data for Mitel 
Superset 430 integration only.  

The Dialogic

®

 PBX Integration Board can determine which of its prompts are 

currently displayed by using the d42_displayex( ) function to retrieve display 
data and read the information for the bottom two rows (last 80 characters).  

The display key prompts and locations may be different in SX-200 
and SX-2000 PBXs with the same Superset 430 phone emulation.  

Refer to the Dialogic

 PBX Integration Software Reference for more 

information about using the d42_displayex( ) function. 

The Dialogic

®

 PBX Integration Board can respond to a prompt and “press” the 

appropriate Display Key using the dx_dial( ) function. Refer to the Dialogic

PBX Integration Software Reference for more information about dialing 
programmable keys. As shown in 

Superset 420/430 telephones is assigned a dial string sequence. By using the 
dx_dial( ) function and the appropriate dial string, the PBX Integration Board 
can press any of its Display (Soft) Keys.