Kenwood TH-D7A Manual Do Utilizador
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
84
CONNECTING THE TRANSPORTER WITH THE HF
TRANSCEIVER
TRANSCEIVER
You can use the optional cables (PG-4R) to connect the
Transporter with the HF transceiver. For these cables,
contact your authorized KENWOOD dealer.
Transporter with the HF transceiver. For these cables,
contact your authorized KENWOOD dealer.
Note:
◆
Switch OFF both the Transporter and HF transceiver before making
the connection.
the connection.
◆
The Transporter automatically transmits its call sign in Morse at
regular intervals because of the legal requirement; therefore, transmit
sidetone must be output from the HF transceiver. On TS-570D or
TS-570S, do not select “OFF” in Menu 21. On TS-870S, use the
MONI control to adjust the volume of sidetone.
regular intervals because of the legal requirement; therefore, transmit
sidetone must be output from the HF transceiver. On TS-570D or
TS-570S, do not select “OFF” in Menu 21. On TS-870S, use the
MONI control to adjust the volume of sidetone.
◆
When the Transporter is too close to the HF transceiver, unwanted
feedback may cause malfunction.
feedback may cause malfunction.
◆
Do not share a regulated power supply between the Transporter and
the HF transceiver. Unwanted feedback may cause malfunction.
the HF transceiver. Unwanted feedback may cause malfunction.
GPS
COM connector
EXT SP jack
MIC connector
I/O unit
HF transceiver
2.5 mm (1/10")
3.5 mm (1/8")
You need not worry about
which end goes to which side
which end goes to which side
I/O
unit
You may install appropriate noise
filters at the shown positions to
prevent unwanted feedback from
causing malfunction.
filters at the shown positions to
prevent unwanted feedback from
causing malfunction.
3.5 mm (1/8")
2-conductor plug
TH-D7 E 83 Sky Command
98.12.4, 0:13 PM
84