blue-seal g1100 Manual Do Utilizador

Revision 4/F3576 

© Moffat Ltd, December 2004 

Hold thermostat faulty  
With the power switch on and illuminated, 
‘Roast ‘n Hold’ switch on and illuminated, and 
the roast (180 minute) timer set to hold, check 
that the hold indicator is illuminated. 
With a cold oven (ie room temperature) check 
that the oven burners are on.  If burners are 
not operating, check the voltage at terminal 2 
of the hold thermostat.  If there is no voltage 
then check wiring. 
If the voltage is correct, and the thermostat is 
adjusted above oven temperature, then check 
for output voltage at terminal 1 (bottom) of 
hold thermostat.  If there is no voltage then 
the thermostat is faulty—replace. 

1)  Undo the screw on the left hand side of 

the control panel. 

1)  Open the oven doors and remove all racks 

and trays from the oven. 

2)  Remove the four baffle securing screws 

from the rear of the oven. 

2)  The control panel can now hinge open 

along its right hand edge. 

3)  Withdraw the baffle from the oven. 

One screw 

1)  Undo the six screws securing the access 

panel to the right hand side panel, and  
remove.