Kenwood LZ-760R Manual Do Utilizador
English
|
17
1. To prevent short circuits, remove the key
from the ignition and disconnect the
·
terminal of the battery.
2. Make the proper input and output cable
connections for each unit.
3. Connect the wiring harness wires in the
following order: ground, battery, ignition.
4. Connect the wiring harness connector to the
unit.
5. Install the unit in your car.
6. Reconnect the
· terminal of the battery.
7. Press the reset button. (See page 3)
2WARNING
• This product is intended for use with 12V DC negative
ground power only. Do not connect it to any other power
supply.
supply.
• To prevent shorting, disconnect the battery cable from the
negative terminal of the battery during installation.
• Be sure to firmly stabilise this product. Do not install it in a
location which is not stable.
• Follow the installation and wiring procedures described in
this manual. Improper wiring or modified installation can
not only result in malfunction or damage to the unit but
may also result in an accident.
not only result in malfunction or damage to the unit but
may also result in an accident.
• Do not install the unit in the following locations.
• A location which interferes with the operation of the air
• A location which interferes with the operation of the air
bag
system.
• A location which is not made of plastic.
\ Installing on leather, wood or cloth may damage the
\ Installing on leather, wood or cloth may damage the
surface.
• A location subject to direct sunlight, subject to the air
from the air conditioner, or subject to moisture or high
temperature.
temperature.
\ This may cause deformation of the monitor unit.
• Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy parts
• Be sure to use the supplied screws for installation.
Using screws longer than those supplied may destroy parts
inside the unit causing it to smoke. Using screws shorter
than those supplied may cause the unit to come looks from
the installation bracket.
than those supplied may cause the unit to come looks from
the installation bracket.
• If you are not going to install the unit using the supplied
monitor stand, be sure to use a commercially available
monitor stand. (Mounting holes for such a stand are located
on the bottom of the monitor unit.)
monitor stand. (Mounting holes for such a stand are located
on the bottom of the monitor unit.)
• If your car’s ignition does not come with an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect the
ignition wire to a power source that receives a constant
voltage supply, as with battery wires, the battery may die.
turned on and off with the ignition key. If you connect the
ignition wire to a power source that receives a constant
voltage supply, as with battery wires, the battery may die.
• If the fuse blows, first make sure that the wires have not
caused a short circuit, then replace the old fuse with one
with the same rating.
with the same rating.
• Do not let unconnected wires or terminals touch metal
on the car or anything else conducting electricity. To
prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
prevent short circuits do not remove the caps from unused
terminals or from the ends of the unconnected wires.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
• Insulate unconnected wires with vinyl tape or other similar
material.
• Thoroughly wipe away oil and other dirt from the
installation surface.
Please avoid installation on uneven surfaces.
• Do not install the video box unit under the carpet.
• Do not install the video box unit under the carpet.
Otherwise heat build-up occurs and the unit may be
damaged.
damaged.
Installation Procedure
LZ-760R_E_(En).indd 17
LZ-760R_E_(En).indd 17
05.6.7 10:29:12 AM
05.6.7 10:29:12 AM