Jacuzzi Plumbing Product Manual Do Utilizador

2

You can determine which tools and materials are necessary by reading the
complete installation instructions and examining the job you have to do.

!

Observe all local plumbing and building codes.

!

Carefully inspect the new toilet for damage.

!

If the existing toilet does not have a supply shut-off valve below the tank, you

will install one before installing the new toilet.

!

Rough-in information is included with your toilet. The rough-in information shown

will be helpful in placing the toilet, water supply piping, shut-off valves and drain
in their proper positions.

CAUTION:  Your new toilet is finished to an attractive high gloss. It may also be heavy
and difficult to lift. To protect the finish and avoid possible damage before and after
installation, please handle your toilet with care. Place the toilet on a thick bed of
newspapers when working on it before installation.

These are normally needed:

5/16" T-bolts w/nuts and washers

basin or pail

flat blade screwdriver

putty knife

drill

metal file

saber saw or keyhole saw

square

emery cloth

cardboard, newspapers or a

dropcloth

sponge

The following materials are optional, in case existing materials are unusable:
Two (2) shut-off valves with 1/2" I.P.S. outlet, (check house piping to determine
valve inlet dimension.),
1/2" I.P.S. hot and cold water supply tubes with compression nut and ferrule,
drain tail pipe and trap,
additional drain pipe as required,
2" x 4" board

Adjustable Wrench

(10")

Wax Ring

Tape Measure

Tubing Cutter

Safety Glasses

Pipe Wrench

(12")

Level

Hacksaw