Jacuzzi j-300 j-335 Manual Do Utilizador

41

1.  Jets may all be closed. Verify all jets are in the open “on” position 

(Sec. 10.5, page 26).

2.  Pump may not be properly primed. This can happen after the spa is 

drained and refilled. Press the JETS 1 button on the control panel 

several times, never leaving the motor running for more than 5 to 10 

seconds at a time. Turn power off and let the air out of spa plumbing 

system by removing the filter cartridge (Sec. 12.1, page 30). Make 

certain you reinstall the filter cartridge before turning on spa power 

and restarting the jets pump 1.

Make sure all jets are in the full open “on” position (page 

• 

26).

Press the JETS 1 button to make certain pump #1 is on.

• 

Verify all air controls are in the "on" position by pressing down on 

• 

Check for dirty filter. Clean, if necessary (Section 12.1, page 

• 

Reduce thermostat setting.

1.  Check thermostat setting.

2.  Keep the spa cover in place while heating.

3.  Check the settings to see if your spa is in economy filtration/heating 

mode (page 28).

Should checking the above steps fail to correct the problem, please call 

your Jacuzzi Hot Tub dealer so that they may arrange service. We build 

the best spas in the industry. Nonetheless, we are always striving to 

improve the quality and features of our products. 

Your input as a Jacuzzi spa owner is a cherished part of this process. If 

you have any comments or suggestions, or if you wish to be informed on 

any new products for your spa, please write to us.

ConGraTulaTIons on your good taste and welcome to the happiest 

and most relaxed family in the world!