Kenwood TK-5220 Manual Do Utilizador

Scan monitors for signals on the transceiver channels.  While 

scanning, the transceiver checks for a signal on each channel 

and only stops if a signal is present.
To begin scanning, press the key programmed as 

Scan.

•  The   icon appears on the display.
•  When a signal is detected on a channel, Scan pauses at that 

channel.  The transceiver will remain on the busy channel until the 

signal is no longer present, at which time Scan resumes.

To stop scanning, press the 

Scan key again.

Note:  To use Scan, there must be at least 2 channels in the scan 

sequence.

During scan, you can temporarily remove specific channels 

from the scanning sequence by selecting them and pressing 

the key programmed as 

Scan Delete/Add.

•  The channel is no longer scanned. However, when scanning is 

ended and restarted, the channels are reset and deleted channels 

will again be in the scanning sequence.

 You can add and remove zones and/or channels to and from 

scan.
1  Select your desired zone and/or channel.
2  Press the key programmed as Zone Delete/Add (to 

add/remove zones) or 

Scan Delete/Add (to add/remove 

channels).

•  You can also press and hold the key programmed as 

Delete/Add to add/remove zones.