Netgear WG302 Manual Do Utilizador
Reference Manual for the NETGEAR ProSafe Wireless Access Point 802.11g WG302
2-6
Introduction
September 2004
Hardware Description
The NETGEAR ProSafe Wireless Access Point 802.11g WG302 front and rear hardware
functions are described below.
The WG302 Access Point provides four status LEDs.
functions are described below.
The WG302 Access Point provides four status LEDs.
Figure 2-1: WG302 front panel
The following table explains the LED indicators:
LED
DESCRIPTION
PWR
Power Indicator
Off
No power. If this LED does not come on with the power adapter and cord correctly
installed, see Chapter 4,
installed, see Chapter 4,
Troubleshooting
.
On
Power is on.
TEST
Self Test Indicator
Blink
Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
Note: This LED may blink for a minute before going off.
100
Ethernet LAN Speed Indicator
Off
Indicates 10 Mbps Ethernet link detected
Green On
100 Mbps Fast Ethernet link detected.
LINK/ACT LAN
Ethernet LAN Link Activity Indicator
Off
Indicates no Ethernet link detected.
Green On
100 Mbps Fast Ethernet link detected, no activity.
Green Blink
Indicates data traffic on the 100Mbps Ethernet LAN.
Amber 0n
10 Mbps Ethernet link detected, no activity.
Amber Blink
Indicates data traffic on the 10Mbps Ethernet LAN.