Netgear WG302 Manual Do Utilizador

4-10

Management

It is sometimes desirable to restore the wireless access point to the factory default settings. This 
can be done by using the Restore function, which restores all factory settings. After a restore, the 
wireless access point's password will be password, the WG302's DHCP client is enabled, the 
default LAN IP address is 192.168.0.228, and the access point name is reset to the name printed on 
the label on the bottom of the unit.

To restore the factory default configuration settings without knowing the login password or IP 
address, you must use the Default Reset button on the rear panel of the wireless access point (see 

). The reset button has two functions:

•

Reboot.  When pressed and released, the Wireless Access Point will reboot (restart).

•

Reset to Factory Defaults.  This button can also be used to clear all data and restore all 
settings to the factory default values.

To clear all data and restore the factory default values:

1.

Power Off the WG302

2.

Hold the Reset Button down while you Power On the WG302 for 5 seconds.

3.

Continue holding the Reset Button until the LEDs blink twice.

4.

Release the Reset Button. 

The factory default configuration has now been restored, and the WG302 is ready for use.

The default password is password. Change this password to a more secure password. You cannot 
change the administrator login name.