Netgear WG302 Manual Do Utilizador

Advanced Configuration

5-9

•

All WG302 Access Points use the same SSID, Channel, authentication mode, if any, and 
encryption in use.

•

All Point-to-Point APs must have AP2’s MAC address in its Remote AP MAC address 
field.

3.

Verify connectivity across the LANs. 

•

A computer on any LAN segment should be able to connect to the Internet or share files 
and printers with any other PCs or servers connected to any of the three LAN segments.

•

Wireless stations will not be able to connect to the WG302 Access Points in the 
illustration above. If you require wireless stations to access any lan segment, you can 
additional WG302 Access Points configured in Wireless Access Point mode to any LAN 
segment.

Note: You can extend this multi-point bridging by adding additional WG302s configured in 
Point-to-Point mode for each additional LAN segment. Furthermore, you can extend the range of 
the wireless network with NETGEAR wireless antenna accessories.

1.

Configure the Operating Mode of the WG302 Access Points.

–

WG302 (AP1) on LAN Segment 1 in Repeater mode with the Remote MAC Address of 
AP2.

–

Configure WG302 (AP2) in Repeater mode with MAC addresses of AP1 and AP3.

AP in Repeater Mode
with client associations

AP in Repeater Mode
with client associations

AP in Repeater Mode
with client associations

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C

E T H E R N E T

R E S E T

5 - 1 2 V D C

Wireless PC
Associated with AP3

Wireless PC
Associated with AP2

Wireless PC
Associated with AP1