Clarion CZ101ER Manual Do Utilizador

18

English

1. This set is exclusively for use in cars with a 

  negative ground 12 V power supply.

2. Read these instructions carefully.

3. Be sure to disconnect the battery “terminal” 

  before starting. This is to prevent short circuits 

  during installation. (Figure 1)

1. Do not open the case. There are no  

  user serviceable parts inside. If you  

  drop anything into the unit during 

  installation, consult your dealer or an  

  authorized Clarion service center.

2.  Use a soft, dry cloth to clean the case.  

Never use a rough cloth, thinner, 

benzine, or alcohol etc. For tough dirt,  

apply a little cold or warm water to a 

soft cloth and wipe off the dirt gently.

Source unit ..........................................

1

Front panel ..........................................

1

Trim ring

 ..............................................

1

Mounting bracket .................................

1

Special screw (M4x42) ........................

1

Screws M5x6 mm ................................

4

Rubber cap ..........................................

1

L-key ....................................................

2

Wire connector ....................................

1

DCP case ............................................

1

Owner’s manual...................................

1

Warranty card ......................................

1

Special screw (Front panel lock) .........

1

Car battery

1) Before Starting ......................................................................

18

2) Package Contents .................................................................

18

3) General Cautions ..................................................................

18

4) Cautions on Installation .........................................................

19

5) Installing the Source Unit ......................................................

19

6) Removing the Source Unit ....................................................

21

7) Wiring and Connections ........................................................

22

8) Connecting the Accessories .................................................. 23