CyberResearch PCIDIO 48H Manual Do Utilizador

 

2.4 Hardware Installation 

The PCI cards are equipped with a plug and play PCI controller,  
it can request base addresses and interrupts in accordance with the PCI 
standard. The system BIOS will install the system resource based on the 
PCI cards’ configuration registers and system parameters (which are set 
by system BIOS).  Interrupt assignment and memory usage (I/O port 
locations) of the PCI cards  can be assigned by system BIOS only. These 
system resource assignments are done on a board-by-board basis.  It is 
not suggested to assign the system resource by any other methods.  

The PCI card can be inserted to any PCI slot without any configuration for 
system resource.  Please note that the PCI system board and slot must 
provide bus

 

-mastering capability to operate this board properly.

1. Turn off your computer 

2. Turn off all accessories (printer, modem, monitor, etc.)  connected to 

your computer. 

3. Remove the cover from your computer. 

4. Set up jumpers on the PCI card. 

5. Select a 32-bit PCI slot. PCI slots are shorter than ISA or EISA slots,  and 

are usually white or ivory.  

6.  Before handling the PCI cards, discharge any static buildup on your 

body by touching the metal case of the computer. Hold the edge and do 
not touch the components.  

7.  Position the board into the  PCI slot you selected.  

8.  Secure the card in place at the rear panel of the system.