brocade-communications-sy rfs6000 Manual Do Utilizador
618
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
1. Use
sensor
command to setup the sensor.
RFController(config-wireless)#sensor default-config ?
ip-mode configure the IP address mode of the sensors
wips-server-ip specify IP addresses of the WIPS server
Select either
ip-mode
or
wips-server-ip
as the sensor parameter.
2. Specify the VLAN over which the sensors are available. This will help the controller detect
them.
RFController(config-wireless)#sensor vlan 10
3. Use
convert-ap
command to convert the selected AP into a sensor directly from the controller.
RFController(config-wireless)#convert-ap 1 sensor
NOTE
To convert multiple APs’ to Sensor, do it one by one and do config modifications.
To convert multiple APs’ to Sensor, do it one by one and do config modifications.