Kenwood KRF-V8030D Manual Do Utilizador

• The batteries are nearing exhaustion.

• Subwoofer is OFF.

• No setup codes registered at for the respec-

tive input(s).

• The remote control is set to a different

operation mode.

• Batteries are exhausted.
• The remote control unit is too far away from

the main system, controlling angle is too
large, or there is an obstacle between the
receiver and the remote.

• The audio cords and system control cords are

not connected properly.

• No software is loaded in the source

component.

• An attempt is made to play a tape which is

being recorded in the cassette deck.

• The remote control has not been set to the

operation mode for the component you wish
to control.

• The microprocessor of the remote control

malfunctions.

• Replace with new batteries to preserve the

currently registered setup information.

$

• Turn the subwoofer ON.

%

• Register a setup code or Non-IR code at the

respective input(s).

3

• Press the 

, 

, or 

 keys to

select the appropriate operation mode.

• Replace with new batteries.

$

• Operate the remote control unit within the

controllable range.

• Connect properly referring to “Setting up the

system”.

8

• Place software in the source component you

want to play.

• Wait until recording has completed.

• Press the 

, 

, or 

 keys to

activate the operation mode for the
component you want to control before
operation.

5

• Reset the microprocessor.

§