Kenwood KAC8101D Manual Do Utilizador

2CAUTION

•  Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location that gets wet, In a dusty location, 
In a place that gets hot, In a place that gets direct sunlight, In a location that gets hit by hot air)

•  Do not install the unit under the carpet. Otherwise heat build-up occurs and the unit may be damaged.
•  Install this unit in a location which allows heat to easily dissipate.

Once installed, do not place any object on top of the unit.

•  The surface temperature of the amplifier will become hot during use. Install the amplifier in a place where 

people, resins, and other substances that are sensitive to heat will not come into contact with it.

•  When making a hole under a seat, inside the trunk, or somewhere else in the vehicle, check that there 

is nothing hazardous on the opposite side such as a gasoline tank, brake pipe, or wiring harness, and be 
careful not to cause scratches or other damage.

•  Do not install near the dashboard, rear tray, or air bag safety parts.
•  The installation to the vehicle should securely fasten the unit to a place in which it will not obstruct driving. 

If the unit comes off due to a shock and hits a person or safety part, it may cause injury or an accident.

•  After installing the unit, check to make sure that electrical equipment such as the brake lamps, turn signal 

lamps and windshield wipers operate normally.

Installation board, etc.
(thickness : 15 mm or more)

Self-tapping screw
(ø4 × 16 mm)

 KAC-8101D_M_English.indd   3

 KAC-8101D_M_English.indd   3

06.1.16   10:17:24 AM

06.1.16   10:17:24 AM