omnitron-systems-technolo gx-tm2 Manual Do Utilizador
3.2
CONFIGURING DIP-SWITCHES
PI
SA
The GX/TM2 plug-in module has two board-mounted DIP-switches. The standalone unit has one bank of
DIP-switches. The locations of the DIP-switches are illustrated below.
DIP-switches. The locations of the DIP-switches are illustrated below.
Switch 1
Switch 4
Left
Switch 1
Switch 8
Bank 2
Bank 1
Right
SW1
SW8
Bank 1
Up
Down
DIP-switch Locations
3.2.1
Board-Mounted Bank 1 Settings
PI
SA
DIP-switch Bank 1 is available on both the plug-in and standalone modules. The table indicates the position
of the switch; Left/Down or Right/Up. As indicated in the DIP-switch location diagram, Left and Right
refers to the plug-in module and Down and Up refers to the standalone module.
of the switch; Left/Down or Right/Up. As indicated in the DIP-switch location diagram, Left and Right
refers to the plug-in module and Down and Up refers to the standalone module.
PI
(Left/Right)
SA
(Up/Down)
Switch
Left/Down
(Factory Default)
Right/Up
SW1
AN:
Fiber Auto-Negotiation
Man:
Fiber Manual Negotiation
SW2
AN:
UTP Auto-Negotiate
UTP Auto-Negotiate
Man:
UTP Manual
UTP Manual
SW3
1000:
UTP 1000Mbps
UTP 1000Mbps
10-100:
UTP 10-100Mbps
UTP 10-100Mbps
SW4
100:
UTP 100Mbps
UTP 100Mbps
10:
UTP 10Mbps
UTP 10Mbps
SW5
FDX:
UTP Full-Duplex
UTP Full-Duplex
HDX:
UTP Half-Duplex
UTP Half-Duplex
SW6 - SW8 See Link Mode DIP-Switch Table in Section 3.2.1.6
3.2.1.1
SW1 - Fiber Auto/Manual Negotiation “AN Man”
When this DIP-switch is in the Auto-Negotiate “AN” position (factory default), the fiber optic port
automatically determines the duplex and pause modes of the connecting fiber optic device. If the connecting
fiber optic device cannot provide the proper signal to indicate its own mode of operation, the DIP-switch
should be set to the Manual mode “Man” position.
automatically determines the duplex and pause modes of the connecting fiber optic device. If the connecting
fiber optic device cannot provide the proper signal to indicate its own mode of operation, the DIP-switch
should be set to the Manual mode “Man” position.
Page 6