Zebra 49834 Manual Do Utilizador
202
170PAX4 Maintenance Manual
57518L-001 Rev. A
3/18/05
Preventive and Corrective Maintenance
Drive System—Stepper Motor
Stepper Motor
This procedure is for installing or replacing the stepper motor. Read these instructions
thoroughly before performing this procedure.
thoroughly before performing this procedure.
Tools Required
Installation Instructions
1.
Refer to
and remove the print engine from the applicator and open
the rear enclosure.
2.
Refer to
and remove the PCB Access Panel.
Loosen the Enclosure Frame
1.
. Remove the mounting screw and nut securing the diagonal brace to the
enclosure frame.
Caution • A qualified service technician must perform this installation.
Caution • Turn OFF (O) the printer and disconnect it from the power source before
performing the following maintenance.
performing the following maintenance.
Phillips Screwdriver Set
Anti-Static Wriststrap and Mat
Standard Hex Key (Allen Wrench) Set
Metric Hex Key (Allen Wrench) Set
Note •
Do not remove the AC power connectors from the AC power switch.