Lowrance electronic 000-0106-72 Manual Do Utilizador

 8 | NEP-2 Installation Manual

Don’t make sharp bends in 

the cables.

Do make drip and service 

loops

Don’t run cables in a way 

that allows water to flow 

down into the connectors.

Do tie-wrap all cables to keep 

them secure

Don’t route the data cables 

in areas adjacent to radar, 

transmitter, or large current 

carrying cables.
Don’t cut or modify the     

antenna cable

Before starting the installation, be sure to turn electrical 

power off. If power is left on or turned on during the 

installation, fire, electrical shock, or other serious injury 

may occur. Be sure that the voltage of the power supply 

is compatible with the NEP-2 module.
The NEP-2 has a voltage rating of 12 V DC or 24 V DC. 

(9 V DC - 32 V DC max range).
The red wire should always be connected to (+) using 

a fuse or thermal breaker (5 Amp) to protect the cable. 

The NEP-2 is protected by an internal auto resetting 

fuse. 
The yellow power control wire has to be either:

Common with the red wire (after fuse or breaker)

 

•

Connected in common to the power control wire of a 

 

•

display or other device.

If yellow wire is not connected; NEP-2 will be off.