Jacuzzi ProTech LCD Manual Do Utilizador

Add the spa water chemicals as recommended by your Jacuzzi Premium
Dealer. Refer to section 13.0 (Page 39) for general guidance.

Keeping the insulating cover in place anytime the spa is not in use will
reduce the time required for heating, thereby minimizing operating costs.
The time required for initial heat-up will vary depending on the starting water
temperature and the capacity of your spa. Smaller spas heat at a rate of
approximately 8 to 10 degrees per hour; larger spas heat at about 4 to 6
degrees per hour. 

A.   Select Sensor Pad: filter 

cycle programming 
features.

B.

Cycle Sensor Pad: 
accesses filter cycle 
program mode and next 
cycle.

C. Mode Sensor Pad: 

switches between 
standard and economy skimming/heating modes (Page 28).

D.

Display Sensor Pad: displays time of day and initiates time setting 
and locking functions.

E.

Invert Sensor Pad: inverts the main 4-digit LCD display.

F.

Warmer + / Cooler - Sensor Pads: these sensors display and 
increase or decrease the temperature setting.  They also display 
other programmable features.

G.

Light Sensor Pad: controls the spa light (Page 17).

H. JETS 1 Sensor Pad: controls the 2-speed pump #1 (Low, High, Off).
I.

JETS 2 Sensor Pad: controls jet pumps 2&3 as follows:

•

In J-350/J-360/J-370 Models: controls high-speed pump #2 (On, Off).

•

In J-380 Models: controls high-speed pump 2&3 (On, Off)

Page 12

*Display shown for example purposes only, actual water temperature 
display will vary