Jacuzzi ProTech LCD Manual Do Utilizador
Page 31
With each press, the currently programmed duration will be shown in the
large four-digit display. Press WARMER ( + ) or COOLER ( - ) to adjust
duration in increments of 15 minutes.
large four-digit display. Press WARMER ( + ) or COOLER ( - ) to adjust
duration in increments of 15 minutes.
4. Press DISPLAY to make the skimming/heating cycle programming char-
acters disappear from the screen and the main display return to showing
the water temperature. If no sensor is pressed within 30 seconds, the
screen automatically returns to the standard water temperature display.
the water temperature. If no sensor is pressed within 30 seconds, the
screen automatically returns to the standard water temperature display.
At any time, you may check the programming of any aspect of any skim-
ming/heating cycle by first pressing CYCLE then moving through the menu
by pressing either CYCLE or SELECT. The programming is changed only by
pressing WARMER ( + ) or COOLER ( - ) during this process.
ming/heating cycle by first pressing CYCLE then moving through the menu
by pressing either CYCLE or SELECT. The programming is changed only by
pressing WARMER ( + ) or COOLER ( - ) during this process.
11.3 Programming The Change Filter Reminder
You new spa is equipped with a programmable “Change
Filter” reminder that appears on the control panel display
after a specified number of days. It is designed to remind
you to clean and/or replace your filter cartridge(s) on a regular basis but
does not affect spa operation in any way. This reminder must be reset at
each filter cleaning interval. It offers a selectable range from 10-120 days
or can be disabled. We recommend an initial setting of 30 days, after
which you can easily determine weather you need to shorten or lengthen
its interval by visually inspecting your filter cartridge. Refer to section 12.1
(page 33) for filter cleaning recommendations.
You new spa is equipped with a programmable “Change
Filter” reminder that appears on the control panel display
after a specified number of days. It is designed to remind
you to clean and/or replace your filter cartridge(s) on a regular basis but
does not affect spa operation in any way. This reminder must be reset at
each filter cleaning interval. It offers a selectable range from 10-120 days
or can be disabled. We recommend an initial setting of 30 days, after
which you can easily determine weather you need to shorten or lengthen
its interval by visually inspecting your filter cartridge. Refer to section 12.1
(page 33) for filter cleaning recommendations.
Programming Instructions
(1) Press the CYCLE sensor six times. The main display reads “FIL”
(1) Press the CYCLE sensor six times. The main display reads “FIL”
indicating the “Change Filter” display program has been accessed.
(2) Press SELECT sensor once to display currently programmed duration or
days elapsed since last filter cleaning interval.
(3) Press UP or DOWN sensor to change duration as follows:
0 - 10 - 20 - 30 - 40 - 50 - 60 - 70 - 80 - 90 - 100 - 110 - 120 - OFF
(4) Press DISPLAY sensor once to save changes and return to the
standard water temperature display. Note: If no sensor is pressed
within 30 seconds, the screen will automatically return to the standard
water temperature display.
within 30 seconds, the screen will automatically return to the standard
water temperature display.
11.4 Programming Circulation Pump Run Time
The control system allows you to easily adjust two separate aspects of
circulation pump operation:
1. The time of day (start time) the circulation pump begins operating.
2. The length of time (duration) the circulation pump operates.
circulation pump operation:
1. The time of day (start time) the circulation pump begins operating.
2. The length of time (duration) the circulation pump operates.
CHANGE
FILTER