Jacuzzi led series j-220 Manual Do Utilizador
page 23
11.2 Economy Filtration/Heating Modes (F4-F6)
Economy filtration/heating modes are typically selected by customers in
warm climates where heat up times are minimized due to higher ambi-
ent temperatures. In these modes, the water temperature is regulated
by the set temperature, low-speed pump, and heater only while a pro-
grammed filtration/heating cycle is running. Note: these modes con-
sume less energy than standard modes F-F3 outlined in the previous
section.
Economy filtration/heating modes are typically selected by customers in
warm climates where heat up times are minimized due to higher ambi-
ent temperatures. In these modes, the water temperature is regulated
by the set temperature, low-speed pump, and heater only while a pro-
grammed filtration/heating cycle is running. Note: these modes con-
sume less energy than standard modes F-F3 outlined in the previous
section.
11.3 Lock Modes (L1-L2)
These modes are designed for use during spa service or to prevent
unauthorized use.
These modes are designed for use during spa service or to prevent
unauthorized use.
11.4 Selecting The Skimmer/Heating Mode
Press and hold both control panel WARMER ( + ) and COOLER ( - )
buttons at the same time, then release. Then press either WARMER
( + ) or COOLER ( - ) button to select skimming/heater mode F-F6 or
lock modes L-L2 on below:
Press and hold both control panel WARMER ( + ) and COOLER ( - )
buttons at the same time, then release. Then press either WARMER
( + ) or COOLER ( - ) button to select skimming/heater mode F-F6 or
lock modes L-L2 on below:
Standard Filtration/Heating Modes (F1-F3)
F1 4 hours of filtration/heating per day (one 2-hour cycle
F1 4 hours of filtration/heating per day (one 2-hour cycle
every 2 hours).
F2 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F3 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Economy Filtration/Heating Modes (F4-F6)
F4 4 hours of filtration/heating per day (one 2-hour cycle
F4 4 hours of filtration/heating per day (one 2-hour cycle
every 2 hours).
F5 6 hours of filtration/heating per day (one 2-hour cycle
every 8 hours).
F6 8 hours of filtration/heating per day (one 2-hour cycle
every 6 hours)
Lock Modes (L1-L2)
L1 Lock out (disables all spa functions to permit filter clean-
L1 Lock out (disables all spa functions to permit filter clean-
ing)
L2 Lock Mode (disables the jets and light buttons to pre vent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled. Example:
the “F3” filtration/heating cycle was enabled prior to choosing lock
mode. The spa continues to perform the “F3” cycle until lock mode
is canceled,
continue to operate as programmed in this mode. The
temperature display flashes when this function is enabled. Example:
the “F3” filtration/heating cycle was enabled prior to choosing lock
mode. The spa continues to perform the “F3” cycle until lock mode
is canceled,