Konica Minolta DiMAGE E203 Manual Do Utilizador

10

INSTALLING A CR-V3 LITHIUM BATTERY

Insert the lithium battery (3).
• Make sure the positive and negative battery terminals are

orientated as illustrated.

This digital camera uses one CR-V3 lithium battery. When replacing the
battery, the mode dial should always be in the off position.

Close the battery-chamber door and slide it up (4) to engage the safety catch.
• If the battery-chamber door is open or the battery is removed for more than fifteen

minutes, the date and time may reset. When the camera is turned on, the monitor
will automatically activate and prompt you to set the calendar and clock (p. 41).

Open the battery-chamber door by sliding the door down (1) to release the
safety catch; the door should spring open (2).

1

2

4

INSTALLING AA BATTERIES

Although camera performance is better with lithium batteries, two AA-size
alkaline or Ni-MH batteries can be used in this camera. The use of Ni-MH
batteries are recommended over alkaline because of longer life.

Install the batteries as shown in the diagram; make sure the positive and
negative battery terminals are orientated correctly.

When using Ni-MH batteries, fully recharge them with a battery charger
suitable for complex electronic equipment. Please consult your vendor
about an appropriate charger.

3

GETTING UP 

AND RUNNING

This section covers the basic operation of the camera. Please read the entire section before moving
on to other sections in the manual. When the camera is initially turned on, the date, time, and menu
language must be set, see page 13.)