Kenwood KDC-MP149 Manual Do Utilizador
3
ENGLISH
Preparation
How to attach/detach the faceplate
2
1
1
2
Do not expose the faceplate to direct
sunlight, excessive heat, or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
avoid places with too much dust or the
possibility of water splashing.
Keep the faceplate in its casing while
detached.
The faceplate is a precision piece of
equipment and can be damaged by shocks
or jolts.
or jolts.
To prevent deterioration, do not touch the
terminals of the unit and faceplate with
your fingers.
your fingers.
How to reset your unit
If this unit fails to operate properly, press the
reset button.
reset button.
The unit returns to factory
settings when the reset
button is pressed.
settings when the reset
button is pressed.
How to prepare the remote
controller (RC-405)
controller (RC-405)
When you use the remote controller for the
first time, pull out the insulation sheet.
first time, pull out the insulation sheet.
If the effectiveness of the remote
controller decreases, replace the battery.
controller decreases, replace the battery.
2
3
4
1
Caution:
Do not set the remote control in hot places
such as on the dashboard.
Lithium battery.
Danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
same or equivalent type.
The battery pack or batteries shall not be
exposed to excessive heat such sunshine,
fire or the like.
fire or the like.
Keep battery out of reach of children and in
original package until ready to use. Dispose
of used batteries promptly. If swallowed
contact physician immediately.
of used batteries promptly. If swallowed
contact physician immediately.
Insulation sheet
Remote controller (RC-405) is equipped
for KDC-MP249/ KDC-MP2049.
for KDC-MP249/ KDC-MP2049.
KDC-MP149/ KDC-3051M/ KDC-315M
can also be remotely controlled with an
optionally purchased remote controller.
optionally purchased remote controller.
The marking of products using lasers
The label is attached to the chassis/case
and says that the component uses laser
beams that have been classified as Class 1.
It means that the unit is utilizing laser
beams that are of a weaker class. There is
no danger of hazardous radiation outside
the unit.
and says that the component uses laser
beams that have been classified as Class 1.
It means that the unit is utilizing laser
beams that are of a weaker class. There is
no danger of hazardous radiation outside
the unit.
Reset button
EN02-15_KDC-MP249[M]f.indd 3
EN02-15_KDC-MP249[M]f.indd 3
7/30/10 11:15:00 AM
7/30/10 11:15:00 AM