Kenwood KAC-9152D Manual Do Utilizador

Self-tapping screws 
(ø5 × 18 mm)

4

Terminal cover (Power terminal)

1

Speaker level input cable

1

Hexagon Wrench

1

Remote cable

1

Remote controller

1

Mounting bracket

1

Self-tapping screws 
(ø2.6 × 12 mm)

2

Since there are large variety of settings and connections possible according to 
applications, read the instruction manual well to select the proper setting and 
connection.
1. Remove the ignition key and disconnect the negative 

- terminal of the 

battery to prevent short circuits. 

2. Set the unit according to the intended usage.
3. Connect the input and output wires of the units.
4. Connect the speaker wires.
5. Connect the power wire, power control wire and grounding wire following this 

order.

6. Install the installation fittings in the unit.
7. Attach the unit.
8. Install the remote controller. (KAC-9152D/8152D only)
9. Connect the negative 

- terminal of the battery.

2CAUTION

•  Do not install in the below locations;

(Unstable location, In a location that interferes with driving, In a location 
that gets wet, In a dusty location, In a place that gets hot, In a place that 
gets direct sunlight, In a location that gets hit by hot air)

•  Do not install the unit under the carpet. Otherwise heat build-up occurs 

and the unit may be damaged.

•  Install this unit in a location which allows heat to easily dissipate.

Once installed, do not place any object on top of the unit.

•  The surface temperature of the amplifier will become hot during use. Install 

the amplifier in a place where people, resins, and other substances that are 
sensitive to heat will not come into contact with it.

•  When making a hole under a seat, inside the trunk, or somewhere else in 

the vehicle, check that there is nothing hazardous on the opposite side 
such as a gasoline tank, brake pipe, or wiring harness, and be careful not to 
cause scratches or other damage.

•  Do not install near the dashboard, rear tray, or air bag safety parts.
•  The installation to the vehicle should securely fasten the unit to a place in 

which it will not obstruct driving. If the unit comes off due to a shock and 
hits a person or safety part, it may cause injury or an accident.

•  After installing the unit, check to make sure that electrical equipment 

such as the brake lamps, turn signal lamps and windshield wipers operate 
normally.

Œ

Remote controller

Self-tapping screw
(ø2.6 × 12 mm)

Mounting bracket

■ Remote controller (KAC-9152D/8152D only)

Installation board, etc.
(thickness : 15 mm or more)

Self-tapping screw
(ø5 × 18 mm)

Hexagon socket 
head cap screw 
(M4 × 8 mm)

Hexagon Wrench

Front side cover 

•  The rear side cover is fixed and cannot be 

removed.

3.KAC-9152D_M_1English.indd   3

3.KAC-9152D_M_1English.indd   3

04.12.7   9:59:52 AM

04.12.7   9:59:52 AM