Kenwood KAC-M845 Manual Do Utilizador

Página de 8
8
  English
Troubleshooting Guide
What might appear to be a malfunction in your unit may just be the result of slight 
misoperation or miswiring. Before calling service, first check the following table for 
possible problems.
PROBLEM
POSSIBLE CAUSE
SOLUTION
No sound.
(No sound from one side.)
(Blown fuse.)
•  Input (or output) cables are 
disconnected.
•  Protection circuit may be activated.
•  Volume is too high.
•  The speaker cord is shorted.
•  Connect the input (or output) cables.
•  Check connections by referring to 
<Protection function>.
•  Replace the fuse and use lower 
volume.
•  After check the speaker cord and fixing 
the cause of the short, replace the fuse.
The output level is too 
small (or too large).
•  The input sensitivity adjusting control 
is not set to the correct position.
•  Adjust the control correctly referring to 
<Controls>.
The sound quality is bad.
(The sound is distorted.)
•  The speakers wire are connected with 
wrong 
9 / · polarity.
•  A speaker wire is pinched by a screw 
in the car body.
•  The switches may be set improperly.
•  Connect them properly checking the 
9 / · of the terminals and wires well.
•  Connect the speaker wire again so that 
it is not pinched by anything.
•  Set switches properly by referring to 
<Controls>.
Specifications
Audio Section ...................................................................... KAC-M845  KAC-M645
Max Power Output  .....................................................................................720 W (180 W × 4)  500 W (125 W × 4)
Rated Power Output
 
Normal (4 Ω) (20 Hz – 20 kHz, 1 % THD) ............................................... 60 W × 4  40 W × 4
 
Normal (2 Ω) (1 kHz, 1 % THD).................................................................... 90 W × 4  60 W × 4
 
Bridged (4 Ω) (1 kHz, 1 % THD).................................................................180 W × 2  130 W × 2
Frequency Response (+0, –3 dB) .................................................................... 5 Hz – 50 kHz  5 Hz – 50 kHz
Sensitivity (rated output) ........................................................................................0.2 V – 5.0 V  0.2 V – 5.0 V
Signal to Noise Ratio ...............................................................................................................94 dB  94 dB
Input Impedance ..................................................................................................................... 10 kΩ  10 kΩ
Low Pass Filter Frequency (-12 dB/oct.).....................................50 – 200 Hz (variable)  50 – 200 Hz (variable)
High Pass Filter Frequency (-12 dB/oct.) ......................................................................80 Hz  80 Hz
General ................................................................................ KAC-M845  KAC-M645
Operating Voltage .................................................................... 14.4 V (11 – 16 V allowable)  14.4 V (11 – 16 V allowable)
Current Consumption .............................................................................................................. 36 A  19 A
Dimensions (W × H × D) .......................................................................330 × 59 × 230 mm  330 × 59 × 230 mm
Weight ...........................................................................................................................................2.9 kg  2.7 kg
• Specifications subject to change without notice.
B64-3924-00_00_M_1English.indd   8
B64-3924-00_00_M_1English.indd   8
07.11.15   11:29:39 AM
07.11.15   11:29:39 AM