Kenwood dnx6190hd Manual Do Utilizador

DNX7190HD/DNX7490BT/DNX6990HD/DNX6190HD/DNX6490BT/DNX5190/DNX5060EX

GPS antenna is installed inside of 
the car. It should be installed as 
horizontally as possible to allow easy 
reception of the GPS satellite signals.
To mount the GPS antenna inside 
your vehicle:

1)  Clean your dashboard or other 

surface.

2)  Peel the backing off of the 

adhesive on the bottom of the 
metal plate (accessory 0).

3)  Press the metal plate (accessory 

0

) down firmly on your 

dashboard or other mounting 
surface. You can bend the metal 
plate (accessory 0) to conform to 
a curved surface, if necessary.

4)  Place the GPS antenna (accessory 

9

) on top of the metal plate 

(accessory 0).

0

9

• Depending on the type of car, reception 

of the GPS satellite signals might not be 

possible with an inside installation.

• The GPS antenna should be installed at 

a position that is spaced at least 12 inch 

(30 cm) from cellular phone or other 

transmitting antennas. Signals from the 

GPS satellite may be interfered with by 

these types of communication.

• Painting the GPS antenna with (metallic) 

paint may cause a drop in performance.

1)  Check the installation position of 

the microphone (accessory -).

2)  Remove oil and other dirt from 

the installation surface.

3)  Install the microphone.
4)  Wire the microphone cable up to 

the unit with it secured at several 
positions using tape or other 
desired method.

-

Fix a cable with a commercial item of tape.

Peel the release coated paper of 
double-face adhesive tape to fix on 
the place shown above.

Adjust the direction of the 
microphone to the driver.