Kenwood dnx7200 Manual Do Utilizador

English

   

|

   

1.  To prevent short circuits, remove the key from the 

ignition and disconnect the 

- terminal of the 

battery.

2.  Make the proper input and output wire 

connections for each unit.

3.  Connect the wire on the wiring harness.
4.  Take Connector B on the wiring harness and 

connect it to the speaker connector in your vehicle.

5.  Take Connector A on the wiring harness and 

connect it to the external power connector on your 
vehicle.

6.  Connect the wiring harness connector to the unit.
7.  Install the unit in your car.
8. Reconnect the 

- terminal of the battery.

9.  Press the reset button.

2WARNING

•  If you connect the ignition wire (red) and the battery wire 

(yellow) to the car chassis (ground), you may cause a short 
circuit, that in turn may start a fire. Always connect those 
wires to the power source running through the fuse box.

•  Do not cut out the fuse from the ignition wire (red) and the 

battery wire (yellow). The power supply must be connected 
to the wires via the fuse. 

The first time you turn on the DNX7200, you must 
wait while the system acquires satellite signals for 
the first time. This process could take up to several 
minutes. Make sure your vehicle is outdoors in an 
open area away from tall buildings and trees for 
fastest acquisition. After the system acquires satellites 
for the first time, it will acquire satellites quickly each 
time thereafter.

¤

•  If the power is not turned ON (or it is ON, but will be OFF 

immediately), the speaker wire may have a short-circuit 
or touched the chasis of the vehicle and the protection 
function may have been activated. Therefore, the speaker 
wire should be checked.

•  If your car’s ignition does not have an ACC position, connect 

the ignition wires to a power source that can be turned on 
and off with the ignition key. If you connect the ignition 
wire to a power source with a constant voltage supply, as 
with battery wires, the battery may die.

•  If the console has a lid, make sure to install the unit so that 

the faceplate will not hit the lid when closing and opening.

•  If the fuse blows, first make sure the wires aren’t touching 

to cause a short circuit, then replace the old fuse with one 
with the same rating.

•  Insulate unconnected wires with vinyl tape or other similar 

material. To prevent a short circuit, do not remove the caps 
on the ends of the unconnected wires or the terminals.

•  Connect the speaker wires correctly to the terminals to 

which they correspond. The unit may be damaged or fail to 
work if you share the 

- wires or ground them to any metal 

part in the car. 

•  When only two speakers are being connected to the 

system, connect the connectors either to both the front 
output terminals or to both the rear output terminals (do 
not mix front and rear). For example, if you connect the 

+ 

connector of the left speaker to a front output terminal, do 
not connect the 

- connector to a rear output terminal.

•  After the unit is installed, check whether the brake lamps, 

blinkers, wipers, etc. on the car are working properly.

•  Mount the unit so that the mounting angle is 30° or less.
•  This unit has the cooling fan (page 5) to decrease the 

internal temperature. Do not mount the unit in a place 
where the cooling fan of the unit are blocked. Blocking 
these openings will inhibit the cooling of the internal 
temperature and result in malfunction.

DNX7200_B54-4531-00_ms2.indd   3

DNX7200_B54-4531-00_ms2.indd   3

06.12.25   13:09:40

06.12.25   13:09:40