Kenwood dnx6160 Manual Do Utilizador

4     DNX SERIES   DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160

2WARNING

•  To prevent a short circuit, never put or leave any 

metallic objects (such as coins or metal tools) inside 
the unit.

•  Do not watch or fix your eyes on the unit’s display 

when you are driving for any extended period.

•  If the unit or the connected unit fails to operate 

properly, press the Reset button. The unit returns to 
factory settings when the Reset button is pressed. 

•  Remove the USB device before pressing the Reset 

button. Pressing the Reset button with the USB 
device installed can damage the data contained in 
the USB device. For how to remove the USB device, 
see <How to Set a Medium / a Device> (page 13).

•  When the unit is turned on after pressing the Reset 

button, the Initial SETUP screen is displayed. (page 
90) 

TAG

Reset button

If the faceplate of this unit is stained, wipe it with a 
dry soft cloth such as a silicon cloth.
If the faceplate is stained badly, wipe the stain off 
with a cloth moistened with neutral cleaner, then 
wipe it again with a clean soft dry cloth.

¤

•  Applying spray cleaner directly to the unit may affect its 

mechanical parts. Wiping the faceplate with a hard cloth 
or using a volatile liquid such as thinner or alcohol may 
scratch the surface or erases characters.

When you turn on the car heater in cold weather, 
dew or condensation may form on the lens in the 
disc player of the unit. Called lens fogging,  this 
condensation on the lens may not allow discs to play. 
In such a situation, remove the disc and wait for the 
condensation to evaporate. If the unit still does not 
operate normally after a while, consult your Kenwood 
dealer.

•  Do not touch the recording surface of the disc.
•  Do not stick tape etc. on the disc, or use a disc with 

tape stuck on it.

•  Do not use disc type accessories.
•  Clean from the center of the disc and move 

outward.

•  When removing discs from this unit, pull them out 

horizontally.

•  If the disc center hole or outside rim has burrs, 

use the disc only after removing the burrs with a 
ballpoint pen etc.

•  Discs that are not round cannot be used.

•  Discs with coloring on the recording surface or 

discs that are dirty cannot be used.

•  This unit can only play the CDs with 

.

  This unit may not correctly play discs which do not 

have the mark.

•  You cannot play a disc that has not been finalized. 

(For the finalization process refer to your writing 
software, and your recorder instruction manual.)

•  If you try to load a 3-inch-disc with its adapter into 

the unit, the adapter might separate from the disc 
and damage the unit.

•  If you experience problems during installation, 

consult your Kenwood dealer.

•  When you purchase optional accessories, check 

with your Kenwood dealer to make sure that they 
work with your model and in your area.

•  Characters that conform to ISO 8859-1 can be 

displayed.

•  The RDS or RBDS feature won’t work where the 

service is not supported by any broadcasting 
station.

To protect the monitor from damage, do not operate 
the monitor using a ball point pen or similar tool with 
the sharp tip. 

B64-4602-00_02_K_En.indd   4

B64-4602-00_02_K_En.indd   4

10.2.18   2:50:11 PM

10.2.18   2:50:11 PM