zektor serialoption Manual Do Utilizador

Button Press

=B<button><CR><LF>

= A one digit ASCII value that indicates the last button pressed on the front panel.

- Switch to channel 1 button.

- Switch to channel 2 button.

- Switch to channel 3 button.

- Switch to channel 4 button.

- Power button.

Lamp Mode Setting

=L<setting><CR><LF>

= A one digit ASCII value that indicates the current Lamp Intensity setting.

- Dim setting.

- Bright setting.

- Automatic bright to dim setting.

- Front panel LEDs turned off. (Note 1)

Note 1: The ‘3’ setting (turn off front panel LEDs) is only available in firmware versions 1.1 and later.

Lamp Intensity Setting

=I<min><space><max><CR><LF>

<min>

= Minimum (dim) intensity of front panel LEDs (Range: 0 - 255).

<max>

= Maximum (bright) intensity of front panel LEDs (Range: 1 - 255).

The ‘I’ command is only available in firmware versions 1.1 and later.

Query Command Status String

=Q<PendingBits><CR><LF>

Return buffered status state of the DVS5.1

= A bitmapped value that indicates the pending status commands.

- Power status string is pending when set.

- Channel status string is pending when set.

- Lamp Intensity status string is pending when set.

- Keypress pending, waiting to be read, when set. (Note 1)

- Unused, always returned as 0.

If an ‘X0<CR>’ command has been issued and any of the above states have change, the command’s status will
be buffered awaiting the proper request to be issued by the controller. This command returns a status of which
HDS4.2 states have changed and need to be read by the controller.

If an ‘X1<CR>’ command has been issued to the HDS4.2, then the results of the ‘Q?<CR>’ command will always
be 0.

Note 1: The ‘KB’ bit is only available in firmware versions 1.1 and later.

Version Status String

=V<version><CR><LF>

Return the HDS4.2 version string.

= A string of ASCII characters that identifies the HDS4.2 and its version.

Bit