jetway v333ur1a Manual Do Utilizador

 
 
 
                                                                                                                                                                                                                                                                                                                                                         

 
 
 

 

      

 

 

 

 (8)  Primary IDE Connector (40-pin block): IDE1 
 

This connector supports the provided IDE hard disk ribbon cable. After connecting 
the single plug end to motherboard, connect the two plugs at other end to your hard 
disk(s). If you install two hard disks, you must configure the second drive to Slave 
mode by setting its jumpers accordingly. Please refer to the documentation of your 
hard disk for the jumper settings. 

 

   

 

 

 (9)  Secondary IDE Connector (40-pin block): IDE2 
 

This connector connects to the next set of Master and Slave hard disks.  Follow the 
same procedure described for the primary IDE connector.  You may also configure 
two hard disks to be both Masters using one ribbon cable on the primary IDE 
connector and another ribbon cable on the secondary IDE connector.