MINOURA e-hyperrim alu-lw Manual Do Utilizador

- 8 -

1197-1 Godo, Anpachi, Gifu 503-2305 JAPAN

Fax +81-584-27-7505 / E-mail: minoura@minoura.jp

http://www.minoura.jp

(for North American residents only)

(for North American residents only)

(for North American residents only)

(for North American residents only)

(for North American residents only)

1996 East Avenue, Hayward, CA 94541-5454 U.S.A.

Fax 1-510-538-5899 / E-mail : MinHelp@ATTglobal.net

FOR MORE INFORMATION

Made & Quality Controlled in Japan

Copyright © 2003-2004  Minoura Co., Ltd.,  All Rights Reserved.

CHANGING TO REMOTE TYPE

(Fig. P)

You can change your dial type Mag unit to be a remote controlable one.

Of course, the opposite way is possible.

1

Remove the dial lever by removing two small

screws.

2

3

4

Remove the bottom spring holder by removing two medium screws

and remove the inside spring.  You should keep a memo where the

bottom pin of the spring was installed for returning to dial type

again.

Change the spring position as shown in the Fig. P.

Place the spring holder onto the spring.  Be sure the top pin is inserted into the slot of the holder.

Twist the spring holder in the direction of clockwis and push down it to fit to the hole on the lower case

then tighten the screws.

5

6

Install the remote cable bracket at the postion where the dial lever sit by the removed small screws in

Step-1.