MINOURA p-600al closet-cyclist 2 Manual Do Utilizador

Type-A: plain type bolt

Type-B: with Spring Washer

Fig. A

Fig. B

Fig.C

Fig. D

P-600AL "Closet Cyclist 2" instructions manual

Upper Hook

Main Pillar

Lower Hook

Reinforcement Bar

Rear Leg

Right Side Front Leg

Height Adjuster

Leg Base Plate

Stainless Band Clip

Thank you for purchasing Minoura "P-600AL Closet Cyclist 2" bicycle 
display stand.  This stand can hold up to two bikes in a narrow space 
vertically in order to save your storage space as much as possible.
Please read this instructions manual to assemble and use the stand correctly 
and safely.

Required Tools for Assembling

Bolt Type Variation

Install both side Front Legs to the 
Leg Base Plate with supplied M6x35 
type-A bolt, Flat washer, Collar and 
M6 Nylon nut. (see Fig. A)

M6 Nylon Nut

Collar

Flat Washer

Left Side

Front Leg

Place the Rear Leg on the Leg 
Base Plate, and apply the Pillar 
Base Plate onto the assembled legs.
Put the M6x40 type-A bolt with  
Spring and Flat washer into the 
front side hole and tighten them 
temporarily. (see Fig. B)

Pillar Base

Plate

M6x40 Bolt

Rear Leg

Put the M6x40 type-A 
bolt with Spring and Flat 
washer into the backside 
hole and tighten firmly.
After that, tighten the front 
side bolt firmly too.
(see Fig. C)

M6x40 Bolt

Insert the Main Pillar onto the 
Pillar Base Plate.
Apply the Backside Leg on the 
back of the Main Pillar, then 
tighten with the supplied two 
M6x18 type-B bolts temporarily 
(not firmly).  (see Fig. D)

Backside Leg

M6x18 Bolt

Main Pillar

1 x 5mm Hex Wrench

1 x 13mm Open Wrench

M6x35 Bolt

Leg Base Plate

MADE IN JAPAN