MINOURA p-60 closet-cyclist Manual Do Utilizador

!

!

2

3

CC-100 “CLOSET-CYCLIST” instruction manual

Please read this instuctions carefully before use.

Thank you for purchasing Minoura CC-100 “Closet-Cyclist” bike

display stand.

This stand can hang off up to two bikes vertically in a narrow space,

so you can place this stand even in a closet in your room.

This stand is designed for standard two wheel

bicycles. Do not use this stand for electric bikes

or tandems. The weight limit for two bikes is 50

kgs. or 110 lbs.

Make sure the stand is used on a level floor.

Failing to set-up and use this stand on a level

floor may cause the stand to fall over and cause

damage or injury.

This stand requires some assembly. You will need a M4 Hex wrench

and a 13 mm spanner in order to assemble Closet-Cyclist completely.

1

Screw the foot adjuster to the nut located on

each leg end.

Insert four M8x55 bolts into the holes on the

bottom of the Lower Pillar, then put through

the legs. The long leg is for rear section, and

the short legs are for front section. Be sure to

fit the legs to the shape of the horrow of the

bottom plate.

(Fig. A)

(Fig. B)

(Fig.C)

Install the Reinforcement Arms between the Lower

Pillar and the Front Legs by tightening the M6x14

bolts for the pillar side, and M6x30 bolts for the

leg side.  After installing the Reinforcement Arms,

tighten the M8x55 bolts firmly. Wrong

step may make you unable to install

the Reinforcement Arms.