husky-liners 56101 Manual Do Utilizador

5610 Jeep Grand Cher#1324BB.doc

Rev: 0

• 

1/8” drill bit / Drill

• 

Center punch / Hammer

• 

Short Phillips screwdriver or drill attachment

• 

Marking utensil (fine tip marker, grease pencil, etc.)

Package Contents
• 

Driver & passenger side mud guard

• 

#10 screw (qty. 6)

• 

Washers (qty. 6)

• 

U-clip (qty. 4)

• 

Paint Protection Film (1set)

• 

Instruction sheet

NOTE:  Turn the front wheels all the way to the left or right for mud guard installation.  However, it may be necessary
              to remove the wheels depending on the tools being used for installation.

1.  Clean and degrease the mud guard location area on the fender before installation.
2.  Remove existing fastener from location B and install a U-clip over sheet metal and align with existing hole (Figures 1 and 2).
3.  Attach mud guard to front fender with #10 screw and washer at location B, thru mud guard, thru fender cladding, and into U-

clip.  Check fit and parallel and adjust accordingly before tightening (Figure 2).

4.  Using mud guard as a template, mark, drill 1/8 hole and install #10 screw and washer at location A (Figure 1).
5.  Using mud guard as a template, mark, drill 1/8 hole and install #10 screw and washer at location A, thru mud guard, fender

cladding and into a u-clip on the backside of liner.  The u-clip is used as a nut, DO NOT clip over liner or sheet metal (Figure
3).

 PAINTING INSTRUCTIONS
1.    Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.    Sand painting surface with 320 grit sand paper.
3.    Apply a coating of flexible primer-adhesion promoter.
4.    Apply a flexible paint as directed by the paint manufacturer