husky-liners 56601 Manual Do Utilizador

                                                                          

5660 Front Instructio#1170F.doc

Rev: 0

Tools Required
• 

1/8” drill bit / Drill

• 

Short #2 Phillips screwdriver

• 

Center punch

• 

Driver & passenger side front mud guard

• 

#10 screw (qty. 4)

• 

Washers (qty. 4)

• 

U-clip (qty. 2)

• 

Paint Protection Film (1 set)

• 

Instruction sheet

NOTE: 

Turn the front wheels all the way to the left or right for mud guard installation.  However, it may be necessary

           to remove the wheels depending on the tools being used for installation.

1.   

Clean and degrease the mud guard location area on the fender before installation.

2.  Remove existing fasteners from locations B and C (Figure 1).
3.  Attach  mud guard to front fender using existing fasteners at locations B and C, check fit and make sure mud guard

is parallel to ground before tightening.

4.  Using the mud guard as a template mark, center punch and drill 1/8” hole at location A and D (Figure 1).

5. 

Install #10 screw and washer at location A.

6. 

Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip.  DO NOT CLIP U-CLIP
OVER FENDER LINER – THE U-CLIP ACTS AS A NUT AND IS PLACED ON THE BACKSIDE OF LINER.

PAINTING INSTRUCTIONS
1.    Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.    Sand painting surface with 320 grit sand paper.
3.    Apply a coating of flexible primer-adhesion promoter.
4.  Apply a flexible paint as directed by the paint manufacturer.