husky-liners 5704 rear Manual Do Utilizador

                                                                          

5704 Rear Instructions.doc

Rev: 0

•

 

1/8” drill bit / Drill

•

 

Short #2 Phillips screwdriver

•

 

Center punch

•

 

Driver & passenger side rear mud guard

•

 

#10 screw (qty. 8)

•

 

U-Clip (qty. 4)

•

 

Instruction sheet

NOTE:  

It may be necessary to remove the rear wheels for mud guard installation.

1.   

Clean and degrease the mud guard location area on the fender before installation.

2.  Remove factory fasteners from locations A and B (Figure 1).
3.  Attach mud guard to rear fender with #10 screws at locations A and B, thru mud guard, fender, fender liner, and

into a U-clip on the backside of the liner (Figure 2). Check fit and alignment before tightening.

NOTE:  The U-Clip is used as a nut for the #10 screw and does not clip over the fender or liner panel.
4.  Using the mud guard as a template, center punch and drill an 1/8” hole at location C and D (Figure 1).

5. 

Install a #10 screw at locations C and D.

PAINTING INSTRUCTIONS
1.    Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.    Sand painting surface with 320 grit sand paper.
3.    Apply a coating of flexible primer-adhesion promoter.
4.  Apply a flexible paint as directed by the paint manufacturer.