husky-liners 56721 Manual Do Utilizador
PART NO.
5672
5672 Colorado w mini-#DB8C4.doc
Rev: 0
CHEVROLET/GMC COLORADO/CANYON WITH MINI-FLARES FRONT MUD GUARD
INSTALLATION INSTRUCTIONS
Install paint protection film before mud guard (see other side).
Please read instructions thoroughly before installation.
Install paint protection film before mud guard (see other side).
Please read instructions thoroughly before installation.
Tools Required:
•
1/8” drill bit / Drill
•
Center punch / Hammer
•
Short Phillips screwdriver or drill attachment
•
Marking utensil (fine tip marker, grease pencil, etc.)
Package Contents
•
•
Driver & passenger side front mud guards
•
#10 screw (6)
•
Washers (6)
•
U-clip (4)
•
Paint Protection Film (1set)
•
Instruction sheet
NOTE: Turn the front wheels all the way to the left or right for mud guard installation. However, it may be necessary
to remove the wheels depending on the tools being used for installation.
to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove existing fastener from location B and install a U-clip (Figure 1).
3. Attach mud guard to front fender with #10 screw and washer at location B. Check mud guard fit and adjust accordingly before
2. Remove existing fastener from location B and install a U-clip (Figure 1).
3. Attach mud guard to front fender with #10 screw and washer at location B. Check mud guard fit and adjust accordingly before
tightening.
4. Using mud guard as a template mark and drill 1/8” holes at locations A and C.
5. Install #10 screw and washer at location A.
6. Install #10 screw and washer at location C, thru mud guard, fender liner and into a U-clip (Figure 2). DO NOT install U-clip over
5. Install #10 screw and washer at location A.
6. Install #10 screw and washer at location C, thru mud guard, fender liner and into a U-clip (Figure 2). DO NOT install U-clip over
fender liner.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer