husky-liners 57361 Manual Do Utilizador
PART NO.
5736
5736 Rear Instructions.doc
Rev: 0
HUMMER H2
REAR MUD GUARDS
REAR MUD GUARDS
INSTALLATION INSTRUCTIONS
Please read instructions thoroughly before installation.
Tools Required
•
Tools Required
•
Short Phillips screwdriver
•
Center punch / Hammer
•
Drill / 1/8” drill bit
Package Contents
•
Driver (LH) & passenger (RH) side front mud guard
•
#10 screw (qty. 6)
•
Washer (qty. 4)
•
U-Clips (qty. 4)
•
Instruction sheet
NOTE: It may be necessary to remove the wheels depending on the tools being used for installation.
1. Clean and degrease the mud guard location area on the fender before installation.
2. Remove factory fasteners from locations A and B (Figure 1).
3. Place mud guard against fender and install #10 screws and washers at locations A and B, through mud guard, through existing
2. Remove factory fasteners from locations A and B (Figure 1).
3. Place mud guard against fender and install #10 screws and washers at locations A and B, through mud guard, through existing
fender holes and into u-clips. NOTE: The u-clips are to be used as a nut and not to be clipped over fender. Check fit and
level before tightening.
level before tightening.
4. Using mud guard as a template, drill an 1/8” hole at location C and install a #10 screw.
PAINTING INSTRUCTIONS
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.
1. Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2. Sand painting surface with 320 grit sand paper.
3. Apply a coating of flexible primer-adhesion promoter.
4. Apply a flexible paint as directed by the paint manufacturer.