husky-liners 57591 Manual Do Utilizador

                                                                          

5759 Rear Instruction#11712.doc

Rev: 0

Tools Required
• 

1/8” drill bit / Drill

• 

Short #2 Phillips screwdriver

• 

Center punch

• 

Driver & passenger side rear mud guard

• 

#10 screw (qty. 8)

• 

Washers (qty. 8)

• 

U-Clip (qty. 2)

• 

Paint Protection Film (1 set)

• 

Instruction sheet

NOTE:  

It may be necessary to remove the rear wheels for mud guard installation.

1.   

Clean and degrease the mud guard location area on the fender before installation.

2.  Remove factory fastener from locations B and place a U-clip over sheet metal and align fastener holes (Figure 1).
3.  Attach mud guard with a #10 screw and washer at location B, check fit and make sure the mud guard is parallel to

the ground before tightening.

4.  Using the mud guard as a template, center punch and drill an 1/8” hole at location A, C, and D (Figure 1).

5. 

Install #10 screws and washers at location A, C, and D.

PAINTING INSTRUCTIONS
1.    Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.    Sand painting surface with 320 grit sand paper.
3.    Apply a coating of flexible primer-adhesion promoter.
4.  Apply a flexible paint as directed by the paint manufacturer.