opcode studio 4 Manual Do Utilizador

Choosing Stripe SMPTE from the 
Studio 4 menu opens the window shown 
above. The following sections discuss the 
mechanics of this window. See the 
SMPTE tutorial later in this chapter for a 
step-by-step striping guide.

The Start field contains the SMPTE start 
time. Reading from left to right, the num-
bers represent hours, minutes, seconds, 
and frames.

The Studio 4 can stop generating time 
code automatically. This is especially 
useful for unattended striping sessions. 
You can enter a stop time value in the 
Stop field. The check box to the left of the 
Stop field turns on the automatic stop fea-
ture. If the box is checked and a value is 
entered into the Stop field, the Studio 4 
will automatically stop sending SMPTE 
timecode when that value is reached. If 
the box is not checked, the Studio 4 will 
ignore the Stop value, and continue strip-
ing until the Stop Striping button is 
clicked.

The Studio 4 will begin to generate 
SMPTE timecode from its SMPTE Out 
jack as soon as the Start Striping button 
is clicked. The SMPTE value will begin at 
the time specified in the Start field. The