sentrol zxlcd Manual Do Utilizador
32
ZONE 00
SELECT ZONE ID
SELECT ZONE ID
ZX200/ZX210 PROGRAMMING
Programming the Zone Names
This operation cannot be performed from an LED or
SSD Control Station. Do not perform this operation
during walk test mode or when any keypad is in use.
SSD Control Station. Do not perform this operation
during walk test mode or when any keypad is in use.
This feature allows you to program a name in for each zone location
(i.e.: zone 1 is the Front Door).
(i.e.: zone 1 is the Front Door).
To program zone names:
1.
Press + at the same time.
The Control Station will display:
2.
Enter zone number: (1 - 8). Press
.
See Protection Zones for a list of zone numbers.
3.
The Control Station will display the zone number selected on the
first line and the zone name to be programmed on the second line.
Press the key associated with each character listed on the next
page to enter in the new zone name. Each keypress will change
the display to the next character listed for that key. A maximum of
12 letters (includes spaces) may be used for each zone name.
first line and the zone name to be programmed on the second line.
Press the key associated with each character listed on the next
page to enter in the new zone name. Each keypress will change
the display to the next character listed for that key. A maximum of
12 letters (includes spaces) may be used for each zone name.
NOTE
ENTER
CLEAR
ENTER