BDI alcove 8200 ch assembly Manual Do Utilizador

These steps are to be followed after you have unpacked and completed the simple assembly instructions for your Alcove 

stand.  Due to jostling in freight or perhaps an uneven floor, the doors on your Alcove stand may not appear to be in perfect 

alignment (Refer to sample cabinet doors shown below).  Making a few minor adjustments can rectify this situa-

tion.  Be aware that depending on your situation, patience and a bit of trial and error are required.  The high-quality Euro-

pean hinge hardware is infinitely adjustable, but changing one element can cause the need for further adjustments.  Through 

a little adjustment, you can modify the orientation of the cabinet doors to make sure that they are sitting perfectly on your 

Alcove unit.

The levelers which are concealed within the base can be adjusted from inside the 

Alcove cabinet to compensate for an uneven floor or to secure your cabinet so that 

it does not roll.  If you are having difficulty with misaligned doors, it is 

recommended that you first retract all levelers and make sure that the unit is resting 

on it’s wheels.  If the center door appears to be sagging (center door hangs below 

the side doors) raise the leveler in the center to compensate for this.

The doors on your Alcove stand should be perfectly 

spaced and the doors should open and close freely with-

out rubbing against the door frame.  Adjustments may be 

made to the Alcove door hinges with the use of a Phillips 

head screwdriver.  The hinge hardware has three 

adjustment screws. 

•  By adjusting Screw 1, the door will move left and right 

within the frame. For best results, make minor adjustments 

to top and bottom hinge for best results.  

•  If adjusting Screw 1 has not achieved the desired result, 

you can adjust Screw 2 and the door will move up and 

down within the frame (the top and bottom hinges need to 

be adjusted the same amount).

•  Adjusting Screw 3 will cause the entire door to move 

in and out, opening and closing the gap between the door 

frame and cabinet.  This screw rarely needs adjustment.

INCORRECT! Door is 

out of alignment with 

the rest of the unit.

CORRECT! Door is 

sitting squarely and 

evenly spaced on tops 

and sides.

HIGH PERFORMANCE FURNITURE