husky-liners 5710-57111 Manual Do Utilizador

                                                 

5710 Jeep Grand Cher#1324C8.doc

Rev: 0

Tools Required
• 

1/8” drill bit / Drill

• 

Center punch / Hammer

• 

Short Phillips screwdriver or drill attachment

• 

Driver & passenger side rear mud guard

• 

#10 screw (qty. 8)

• 

Washers (qty. 8)

• 

U-clip (qty. 4)

• 

Paint Protection Film (1 set)

• 

Instruction sheet

 NOTE:  It may be necessary to remove the wheels depending on the tools being used for installation.

1.  Clean and degrease the mud guard location area on the fender before installation.
2.  Remove existing fastener from location C (Figure 1).
3.  Attach mud guard to rear fender with a #10 screw and washer, thru mud guard, fender, fender liner and into a U-clip on the

backside of the fender liner (Figures 1 & 2).  Check fit and level before tightening.

4.  Using mud guard as a template, mark and drill 1/8” holes at locations A, B, and D.
5.  Install #10 screws and washers at locations A and B (Figure 1).
6.  Install #10 screw and washer at location D, thru mud guard, fender liner and into a U-clip placed on the backside of fender liner

(Figure 2).

PAINTING INSTRUCTIONS
1.    Clean mud guard with a soap and water solution to remove dirt and other contaminates.
2.    Sand painting surface with 320 grit sand paper.
3.    Apply a coating of flexible primer-adhesion promoter.
4.    Apply a flexible paint as directed by the paint manufacturer.