husky-liners 21771 Manual Do Utilizador

2177.doc

05/19/2004

CARE AND USE INSTRUCTIONS

     Your new liner is custom molded to fit your vehicle. Upon removal from the box your liner will not completely

unroll and lay flat. This is normal and only temporary. Just place the liner on the floor or in the back of your

vehicle with a weight in each corner (a book works well). After about 15 minutes, your liner will remain flat. In

colder climates this “relaxing” may take longer; moving the liner inside will speed up the process.

     Your liner is manufactured using an engineering resin that is lightweight and extremely tough and durable. The

easiest way to clean your liner is with a damp cloth or sponge. If using a cleaner, 409

®

 or Glass Plus

®

 work well.

Use of Armor All

®

, Son-of-a-Gun

®

 or similar items is discouraged as these products make the liner slick.

TO ACCESS THE FACTORY CHILD SEAT SAFETY RESTRAINT ANCHORS, TRIM AWAY THE

MATERIAL FROM THE TOPS OF THE TWO (2) RAISED AREAS (SHOWN ABOVE DARKENED).

NOTE:  TO  ACCESS  THE  REAR  SEAT
SEAT  BELTS,  PULL  THEM  UP
THROUGH  THE  HOLE  PROVIDED  IN
RAISED AREA  (SEE AREA “1” BELOW).

NOTE:  TO  ACCESS  THE  FACTORY  CARGO  TIE-
DOWN  HOOKS  WITH  YOUR  LINER  IN  PLACE,  YOU
MUST  TRIM  AWAY  THE  MATERIAL  FROM  THE
TOPS OF THE 6 CARGO TIE-DOWN AREAS (SHOWN
CIRCLED).  THESE  AREAS  ARE  RAISED  SLIGHTLY
ABOVE THE SURFACE OF THE LINER.

1