Becker 7802 dtm Manual Do Utilizador
136
7HFKQLFDO'DWD
7HFKQLFDO'DWD
:DYHEDQGV
:
FM 87.5 MHz - 108 MHz
MW 531 kHz - 1620 kHz
LW 153 kHz - 282 kHz
SW 5800 kHz - 6250 kHz
MW 531 kHz - 1620 kHz
LW 153 kHz - 282 kHz
SW 5800 kHz - 6250 kHz
)UHTXHQF\UDQJH
:
20 Hz - 20 kHz for CD operations
30 Hz - 15 kHz for FM
50 Hz - 2.5 kHz for MW, LW, SW
30 Hz - 15 kHz for FM
50 Hz - 2.5 kHz for MW, LW, SW
2XWSXWSRZHU
:
4 x 18 Watt
/LQHFURVVVHFWLRQ
:
min. 0.75 mm²
/RXGVSHDNHULPSHGDQFH
:
min. 4
Ω
/LQHRXW
:
4 x analogue Line Out (Ua max 3Veff at 10 k
Ω
)
*$/
:
In order to utilise the GAL, a square wave voltage
with a mass-related amplitude of +4 V - +12 V must come from the electronic tachometer of
the vehicle. Volume increase takes places in 7 increments of 2.5 dB each.
with a mass-related amplitude of +4 V - +12 V must come from the electronic tachometer of
the vehicle. Volume increase takes places in 7 increments of 2.5 dB each.
$QWHQQD
:
Impedance 50
Ω
$)7HOHSKRQHLQSXW
:
Max. input voltage of 8 V (if interference occurs, a commercially-available 1 : 1 carrier
should be connected to the signal lead).
should be connected to the signal lead).
$8;,QSXW
:
16 K
Ω
Input resistance, max. input voltage 1.7 Veff
7HOHSKRQH0XWH
:
Low active level < 2 Volt
6XSSO\YROWDJH
:
12 Volt
&'&RQQHFWLRQ
:
The Becker Silverstone 2630 and Silverstone 2660 CD changers can be connected.
3OD\DEOH&'V
:
Only those CDs which comply with DIN EN 60908 can be used.
The use of 8 cm CDs with adapter is not recommended.
The use of 8 cm CDs with adapter is not recommended.